Winnerwell Flashing KitSKU: 910311
Winnerwell Flashing Kit
Perfect fit with both the S-Sized / L-Sized Double Wall Heat Protector and the S-Sized and M-Sized Triple Wall Heat Protector. The Winnerwell Flashing Kit is made from high temperature resistant silicone and is held in place by stainless steel washers with six wing nuts. This Flashing Kit can be used to create a weatherproof seal on existing stove connections or when installing a stove jack in a tent or shelter.
Note: Please note that the flashing kit can only be used with the Double Wall Heat Protector S/M/L or Triple Wall Heat Protector S/M. If You have a WinnerwellTriple Wall Heat Protector | L-Sized, then we recommend the Winnerwell Flashing Kit Large
Make sure that you have at least 1.20 - 1.50 meters of pipe section/triple between the stove and this flashing kit. Otherwise it will get too hot and you risk melting the slicone!
The Flashing Kit must be installed in the position below the 5th row of the holes of the Heat Protector Chimney (if you have a triple tube, cut a double tube then the flashing kit must be mounted below the holes of the exhaust holes). If the flashing kit and tube are mounted at an angle, make sure that the flashing kit is placed in its entirety under the 5th row of these holes. We recommend purchasing Winnerwell® Short Pipes separately for height adjustment to meet the position requirement specified above.
When the flashing kit is installed in the tent, but you are not using a tent stove, you can close the flashing kit with the Winnerwell Rainproof Plate. This plate perfectly fits this flashing kit and closed the hole if no tent stove is installed. It prevents rain, snow and debris to enter the tent.
- Perfect fit with:
- Double wall Heat Protector S-M-and L-Sized
- Triple wall Heat Protector S- and M-Sized
- Made with silicone to withstand high temperatures, creates a tight seal around the tube and provides flexibility
- Inner Diameter: 12 cm / 4.7" inch
- Outer Diameter: 22 cm / 8.7" inch)
- Stainless steel washers and 6 wing nuts hold the Flashing Kit in place
- To be used with existing stove connections or when installing a stove connection in a tent or shelter
- Material tube: silicone
- Material ring and wing nuts: 304 stainless steel
Warning 1: If you use the flashing kit without the double or triple wall heat protector, the silicone will get too hot and you run the risk of fire!
Warning 2: The temperature at the top part of the Heat Protector Chimney is high, the silicone part must avoid the position of the top cooling holes.